*** MIDAS logfile (03SEPpl1.2) *** Th, 27 Oct 2005 18:42:28 Page 1 *** MIDAS logfile (vers. 03SEPpl1.2) *** Th, 27 Oct 2005 18:43:37 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#rA2 TAKEN ON 051027 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 355.56 stddev = 10.37 FIERA temperature = 291.0 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_rA2_051027 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 1.00 976.0 976.6 842.6 -0.02 0.00 1.16 2 2.00 1869.9 1870.4 1522.7 -0.01 -0.00 1.23 3 4.00 3660.4 3660.5 2841.0 0.06 0.06 1.29 4 6.00 5449.5 5448.7 4183.2 0.07 0.06 1.30 5 9.00 8130.2 8129.5 6198.9 0.04 0.03 1.31 6 12.00 10813.8 10812.5 8193.9 0.05 0.04 1.32 7 15.00 13491.6 13494.3 10077.5 0.02 0.03 1.34 8 20.00 17955.8 17956.1 13256.5 -0.01 -0.02 1.35 9 25.00 22413.3 22414.7 16999.3 -0.07 -0.06 1.32 10 30.00 26864.2 26863.1 19630.8 -0.12 -0.13 1.37 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 1330 to 36596 e- Average count rate measured: 894 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.36 +/- 0.01 e-/ADU RON = 14.13 +/- 0.12 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = 0.095 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.07/-0.12 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay