*** MIDAS logfile (03SEPpl1.2) *** Th, 20 Oct 2005 16:54:05 Page 1 *** MIDAS logfile (vers. 03SEPpl1.2) *** Th, 20 Oct 2005 16:55:05 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#rA2 TAKEN ON 051020 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 355.43 stddev = 10.19 FIERA temperature = 291.5 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_rA2_051020 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 1.00 977.8 977.9 840.7 -0.05 0.01 1.16 2 2.00 1876.1 1875.4 1514.3 -0.03 -0.03 1.24 3 4.00 3673.5 3673.9 2839.9 0.06 0.06 1.29 4 6.00 5470.4 5469.6 4206.8 0.06 0.06 1.30 5 9.00 8163.2 8162.9 6217.1 0.04 0.03 1.31 6 12.00 10857.8 10858.0 8124.7 0.05 0.04 1.34 7 15.00 13550.3 13550.0 10050.4 0.04 0.02 1.35 8 20.00 18032.3 18033.1 13321.9 -0.01 -0.02 1.35 9 25.00 22509.6 22510.9 16413.3 -0.05 -0.06 1.37 10 30.00 26979.9 26980.5 19864.2 -0.11 -0.12 1.36 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 1345 to 37103 e- Average count rate measured: 898 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.38 +/- 0.01 e-/ADU RON = 14.01 +/- 0.05 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = 0.092 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.06/-0.11 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay