*** MIDAS logfile (03SEPpl1.2) *** Fr, 14 Oct 2005 17:08:43 Page 1 *** MIDAS logfile (vers. 03SEPpl1.2) *** Fr, 14 Oct 2005 17:09:48 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#rA2 TAKEN ON 051014 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 356.93 stddev = 9.94 FIERA temperature = 291.6 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_rA2_051014 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 1.00 976.6 976.9 831.6 -0.03 -0.01 1.17 2 2.00 1875.0 1874.0 1504.8 0.01 -0.02 1.25 3 4.00 3673.2 3673.2 2855.7 0.06 0.07 1.29 4 6.00 5470.6 5470.0 4174.0 0.07 0.06 1.31 5 9.00 8164.0 8162.9 6180.6 0.04 0.03 1.32 6 12.00 10858.5 10858.8 8272.2 0.04 0.04 1.31 7 15.00 13551.3 13551.5 10639.8 0.02 0.03 1.27 8 20.00 18033.7 18034.3 13673.7 -0.02 -0.02 1.32 9 25.00 22513.6 22513.0 16593.1 -0.06 -0.06 1.36 10 30.00 26983.7 26983.4 19903.8 -0.13 -0.12 1.36 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 1326 to 36641 e- Average count rate measured: 898 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.36 +/- 0.01 e-/ADU RON = 13.49 +/- 0.14 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = 0.090 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.07/-0.12 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay