*** MIDAS logfile (03SEPpl1.2) *** Th, 27 Oct 2005 17:47:03 Page 1 *** MIDAS logfile (vers. 03SEPpl1.2) *** Th, 27 Oct 2005 17:48:33 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#rA1 TAKEN ON 051027 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 592.29 stddev = 16.02 FIERA temperature = 291.0 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_rA1_051027 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 4.00 948.5 948.4 1035.3 0.03 0.02 0.92 2 8.00 1870.6 1870.6 1731.9 -0.01 -0.01 1.08 3 16.00 3711.2 3711.4 3145.2 -0.13 -0.12 1.18 4 24.00 5563.0 5562.6 4551.3 0.04 0.03 1.22 5 36.00 8327.0 8327.7 6594.4 -0.02 -0.01 1.26 6 48.00 11100.1 11100.2 8589.3 0.03 0.04 1.29 7 60.00 13868.7 13868.2 10546.8 0.03 0.03 1.31 8 80.00 18478.5 18478.4 13846.6 0.01 0.01 1.33 9 100.00 23094.0 23094.0 16820.4 0.02 0.02 1.37 10 120.00 27701.4 27703.3 19873.6 -0.00 0.00 1.39 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 1342 to 39203 e- Average count rate measured: 231 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.42 +/- 0.01 e-/ADU RON = 22.66 +/- 0.22 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = 0.113 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.04/-0.12 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay