*** MIDAS logfile (03SEPpl1.2) *** Th, 20 Oct 2005 16:01:40 Page 1 *** MIDAS logfile (vers. 03SEPpl1.2) *** Th, 20 Oct 2005 16:02:55 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#rA1 TAKEN ON 051020 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 591.32 stddev = 15.64 FIERA temperature = 291.4 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_rA1_051020 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 4.00 952.3 952.3 1007.7 0.02 0.02 0.95 2 8.00 1878.5 1878.6 1679.7 -0.01 0.01 1.12 3 16.00 3727.4 3727.3 3150.6 -0.12 -0.12 1.18 4 24.00 5586.7 5586.7 4545.8 0.02 0.02 1.23 5 36.00 8363.7 8363.9 6584.1 -0.02 -0.02 1.27 6 48.00 11149.2 11149.5 8656.3 0.03 0.03 1.29 7 60.00 13930.2 13930.4 10576.6 0.04 0.03 1.32 8 80.00 18560.8 18560.4 13794.1 0.01 0.01 1.35 9 100.00 23196.6 23195.9 16873.1 0.02 0.01 1.37 10 120.00 27826.0 27825.6 19999.3 0.00 -0.00 1.39 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 1346 to 39323 e- Average count rate measured: 232 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.41 +/- 0.01 e-/ADU RON = 22.11 +/- 0.20 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = 0.110 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.03/-0.12 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay