*** MIDAS logfile (05SEPpl1.2) *** Su, 15 Oct 2006 15:01:04 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Su, 15 Oct 2006 15:01:57 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#31 TAKEN ON 061015 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 608.55 stddev = 3.47 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_31_061015 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 4.21 2079.9 2085.6 756.2 -0.01 0.07 2.75 2 8.41 4090.2 4087.4 1492.2 0.10 -0.05 2.74 3 16.81 8094.9 8091.8 2944.8 -0.05 -0.10 2.75 4 25.21 12096.8 12098.2 4334.7 -0.12 -0.10 2.79 5 37.82 18119.3 18119.1 6534.7 -0.08 -0.07 2.77 6 50.42 24149.5 24145.8 8791.8 -0.01 -0.01 2.75 7 63.03 30188.6 30185.8 10952.0 0.04 0.06 2.76 8 84.04 40235.3 40229.5 14666.8 0.06 0.07 2.74 9 105.05 50271.4 50273.7 18198.9 0.05 0.08 2.76 10 126.05 60289.3 60286.3 21176.0 0.02 0.05 2.85 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 5848 to 169271 e- Average count rate measured: 478 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 2.81 +/- 0.02 e-/ADU RON = 9.75 +/- 0.09 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = 0.150 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.09/-0.11 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay